INHALT

Regulation No 80 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of seats of large passenger vehicles and of these vehicles with regard to the strength of the seats and their anchorages

Regulation No 80 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of seats of large passenger vehicles and of these vehicles with regard to the strength of the seats and their anchorages
1. SCOPE
2. DEFINITIONS
3. APPLICATION FOR APPROVAL
4. APPROVAL
5. REQUIREMENTS FOR SEATS
6. REQUIREMENTS FOR SEAT ANCHORAGES OF A VEHICLE TYPE
7. REQUIREMENTS FOR INSTALLATION OF SEATS IN A VEHICLE TYPE
8. CONFORMITY OF PRODUCTION
9. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
10. MODIFICATION AND EXTENSION OF APPROVAL OF THE SEAT TYPE AND/OR THE VEHICLE TYPE
11. PRODUCTION DEFINITELY DISCONTINUED
12. TRANSITIONAL PROVISIONS
13. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS AND OF ADMINISTRATIVE DEPARTMENTS
Appendix 1
1. Requirements
2. Preparation of the seat to be tested
3. Dynamic tests
3.1. Test 1
3.2. Auxiliary seat
3.3. Manikin
3.4. Impact simulation
3.5. Test 2
Figure 1
Appendix 2
Test procedure for the anchorages of a vehicle in application of paragraph 6.1.1
1. Test apparatus
2. Test procedure
Appendix 3
MEASUREMENTS TO BE MADE
2.1. Measurements to be made on the trolley
2.2. Measurements to be made on manikins
Appendix 4
DETERMINATION OF ACCEPTABILITY CRITERIA
1. Head acceptability criterion (HAC)
2. Thorax acceptability criterion (ThAC)
3. Femur acceptability criterion (FAC)
Appendix 5
STATIC TEST REQUIREMENTS AND PROCEDURE
1. Requirements
2. Static tests
2.1. Test apparatus
2.2. Test procedure
Figure 1
Static test apparatus
Appendix 6
Energy absorption characteristics of the rear part of seat backs
ANNEX 1
COMMUNICATION
(maximum format: A4 (210 × 297 mm))
ANNEX 2
COMMUNICATION
(maximum format: A4 (210 × 297 mm))
ANNEX 3
ARRANGEMENTS OF APPROVAL MARKS
1. Arrangement in the approval mark for a seat
2. Arrangement of the approval mark for a vehicle type
ANNEX 4
Procedure for determining the ‘H’ point and the actualtorso angle for seating position in motor vehicles
1. PURPOSE
2. DEFINITIONS
3. REQUIREMENTS
3.1. Data presentation
3.2. Relationship between measured data and design specifications
4. PROCEDURE FOR ‘H’ POINT AND ACTUAL TORSO ANGLE DETERMINATION
4.7.1. Designated seating position: driver and outside front passenger
4.7.2. Designated seating position: outboard rear
4.7.3. Other designated seating positions:
Appendix 1
Description of the three dimensional ‘H’ point machine
(1)
(3 DH machine)
1. Back and seat pans
2. Body and leg elements
Figure 1
3 DH machine elements designation
Figure 2
Dimensions of the 3 HD machine elements and load distribution
Appendix 2
THREE-DIMENSIONAL REFERENCE SYSTEM
Figure
Three-dimensional reference system
Appendix 3
REFERENCE DATA CONCERNING SEATING POSITIONS
1. Coding of reference data
2. Description of vehicle measuring attitude
2.1. Co-ordinates of fiducial marks
3. List of reference data
3.1.1. Co-ordinates of ‘R’ point
3.1.3. Specifications for seat adjustment(1)