Regulation No 91 of the Economic Commission for Europe of the United Nations ... (42010X0630(04))
INHALT
Regulation No 91 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of side-marker lamps for motor vehicles and their trailers
- Regulation No 91 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of side-marker lamps for motor vehicles and their trailers
- 1. SCOPE
- 2. DEFINITIONS
- 3. APPLICATION FOR APPROVAL
- 4. MARKINGS
- 5. APPROVAL
- 6. GENERAL SPECIFICATIONS
- 7. INTENSITY OF LIGHT EMITTED
- 8. COLOUR OF LIGHT EMITTED
- 9. TEST PROCEDURE
- 10. MODIFICATION OF SIDE-MARKER LAMP TYPE AND EXTENSION OF APPROVAL
- 11. CONFORMITY OF PRODUCTION
- 12. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 13. PRODUCTION DEFINITELY DISCONTINUED
- 14. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS, AND OF ADMINISTRATIVE DEPARTMENTS
- 15. TRANSITIONAL PROVISIONS
- ANNEX 1
- MINIMUM ANGLES REQUIRED FOR LIGHT DISTRIBUTION IN SPACE
- ANNEX 2
- COMMUNICATION
- (Maximum format: A4 (210 × 297 mm))
- ANNEX 3
- ARRANGEMENTS OF APPROVAL MARKS
- Example 1(a)
- Example 1(b)
- Example 2
- MODEL A
- MODEL B
- MODEL C
- Example 3
- Example 4
- Light source modules
- ANNEX 4
- PHOTOMETRIC MEASUREMENTS
- 1. Measurement methods
- 2. Tables of light distribution
- 2.1. SM1 category of side-marker lamps
- 2.2. SM2 category of side-marker lamps
- 3. Photometric measurement of lamps
- 3.1. For non-replaceable light sources (filament lamps and other):
- 3.2. For replaceable filament lamps:
- ANNEX 5
- Colour of light emitted: lights for chromaticity coordinates
- ANNEX 6
- MINIMUM REQUIREMENTS FOR CONFORMITY OF PRODUCTION CONTROL PROCEDURES
- 1. GENERAL
- 2. MINIMUM REQUIREMENTS FOR VERIFICATION OF CONFORMITY BY THE MANUFACTURER
- 2.1. Nature of tests
- 2.2. Methods used in tests
- 2.3. Nature of sampling
- 2.4. Measured and recorded photometric characteristics
- 2.5. Criteria governing acceptability
- ANNEX 7
- MINIMUM REQUIREMENTS FOR SAMPLING BY AN INSPECTOR
- 1. GENERAL
- 2. FIRST SAMPLING
- 2.1. The conformity is not contested
- 2.2. The conformity is contested
- 2.3. Approval withdrawn
- 3. REPEATED SAMPLING
- 3.1. The conformity is not contested
- 3.2. The conformity is contested
- 3.3. Approval withdrawn
- Figure 1
Feedback