Regulation No 30 of the Economic Commission for Europe of the United Nations ... (42008X0730(01))
Regulation No 30 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of pneumatic tyres for motor vehicles and their trailers
- Regulation No 30 of the Economic Commission for Europe of the United Nations (UN/ECE) — Uniform provisions concerning the approval of pneumatic tyres for motor vehicles and their trailers
- Revision 3
- 1. SCOPE
- 2. DEFINITIONS
- 3. MARKINGS
- 4. APPLICATION FOR APPROVAL
- 5. APPROVAL
- 6. REQUIREMENTS
- 6.1. Dimensions of tyres
- 6.1.1. Section width of a tyre
- 6.1.2. Outer diameter of a tyre
- 6.1.3. Method of measuring pneumatic tyres
- 6.1.4. Tyre section-width specifications
- 6.1.5. Tyre outer-diameter specifications
- 6.2. Load/speed performance test
- 6.3. Tread-wear indicators
- 7. MODIFICATIONS OF THE TYPE OF PNEUMATIC TYRE AND EXTENSION OF APPROVAL
- 8. CONFORMITY OF PRODUCTION
- 9. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
- 10. PRODUCTION DEFINITIVELY DISCONTINUED
- 11. TRANSITIONAL PROVISIONS
- 12. NAMES AND ADDRESSES OF TECHNICAL SERVICES RESPONSIBLE FOR CONDUCTING APPROVAL TESTS AND OF ADMINISTRATIVE DEPARTMENTS
- Explanatory figure
- (see paragraph 2 of the Regulation)
- ANNEX I
- COMMUNICATION
- (maximum format: A4 (210 × 297 mm))
- ANNEX II
- Example of the arrangement of the approval mark
- ANNEX III
- Arrangement of tyre markings
- 1. Example of the markings to be borne by type of tyres placed on the market after the entry into force of this Regulation
- ANNEX IV
- ANNEX V
- ANNEX VI
- Method of measuring pneumatic tyres
- ANNEX VII
- Procedure for load/speed performance tests
- 1. PREPARING THE TYRE
- 2. CARRYING OUT THE TEST
- 3. PROCEDURE TO ASSES THE ‘FLAT TYRE RUNNING MODE’ OF ‘RUN FLAT SYSTEM’
- 4. EQUIVALENT TEST METHODS
Feedback